Automatic Driver Installation With Serverstart; Adapter Numbers - Fujitsu 1PRIMERGY RX600 S4 User Manual

Chapter 2 Checking before OS Installation
Display of onboard LAN
Display of an onboard LAN on the OS is as below when OS installation is performed with ServerStart.
LAN port
Onboard LAN
I/O riser card LAN

Adapter numbers

For ServerStart, onboard multiple LAN adapters (network adapter) can be configured with OS
installation wizard. To configure multiple LAN cards, select the adapter numbers in order of Adapter 1
and Adapter 2, and enter settings for each adapter. Note that the order of adapter numbers is not
necessarily the same as the order of slots for the installed LAN adapters. This means that the setting for
Adapter 1 is not always applied to the onboard LAN. After installing the OS, check the LAN adapters to
make sure that they are configured as intended.
Setting up printers
ServerStart does not support setup of printers. Perform installation after setup is completed.

2.3.4 Automatic Driver Installation with ServerStart

ServerStart supports automatic driver installation for the following expansion cards.
Onboard controller or card type
Onboard IDE/SATA
Onboard LAN
I/O riser card (standard)
Onboard VGA
SAS array controller card (standard)
LAN card
SAS array controller card
SAS card
SCSI card
Fibre channel card
50
table: Display of onboard LAN
Property on
My Network
Local Area Connection
Intel
Local Area Connection
Intel
table: Automatic driver installation
–
–
–
–
–
PG-289 / PG-288 / PG-2861
PG-244C / PG-248G1
PG-228B / PG-224B
PG-2281
PG-FC202
LAN device name
®
PRO/1000 EB Network Connection with I/O Acceleration
®
82575EB Gigabit Network Connection
Product ID Bus
–
PCI-E
PCI-E
PCI
PCI-E
PCI-E
PCI-E
PCI-E
PCI-E
PCI-E