Creating A Team - Fujitsu 1PRIMERGY RX600 S4 User Manual

Chapter 4 Operations after OS Installation

Creating a team

1
Click [Start] – [Administrative Tools] – [Computer Management] to start up
®
Intel PROSet.
2
Under [Device Manager], click [Network adapters], and double-click a LAN
adapter to be incorporated in a team.
3
Click the [Teaming] tab, select [Team with other adapters], and click [New
Team].
4
Enter a team name, and click [Next].
5
Check the LAN adapter to be incorporated in the Team, and click [Next].
6
Select a Teaming type with which a Team will be created, and click [Next].
Select the following Teaming type depending on team type:
• AFT: "Adapter Fault Tolerance"
• ALB: "Adaptive Load Balancing"
• SFT: "Switch Fault Tolerance"
• Static Link: "Static Link Aggregation"
• Dynamic link: "IEEE802.3ad dynamic link aggregation"
7
Click [Finish].
8
Click [OK] to close the property window of the created Teaming adapter.
The property window of the LAN adapter appears.
When the message "This team includes an adapter other than Intel
"One or more adapters in the team do not support ****. **** is disabled." appears, click [OK].
9
Click [OK] to close the property window of the LAN adapter.
When the Teaming setting is completed, the following virtual adapter will be created.
• "Team:(Team Name)"
Upper protocols will be bound with the main virtual adapter.
They can not be bound with the LAN card included in a Team.
The IP address can be set on the main virtual adapter.
104
®
, and **** cannot be used." or