Memory Dump File Setting - Fujitsu 1PRIMERGY RX600 S4 User Manual

Kernel memory dump
Information of only kernel memory space is recorded. The file is stored in the directory displayed in the
[Dump file] box. Capacity required for kernel memory dump is as follows.
• Paging file: Depending on installed physical memory amount
For memory of 256 to 1,373MB - Installed physical memory × 1.5
For memory of 1,374MB or more - 32-bit system: 2GB + 16MB, 64-bit system: Installed physical
memory + 128MB
• Memory dump file: Depending on the kernel-mode address space being used during STOP
Small memory dump
Minimum information to identify a problem is recorded. When this option is selected, a new file is
created each time the system unexpectedly stops.
Those file histories are stored in the directory displayed in [Small dump directory].
• Paging file: Minimum 2MB
• Memory dump file: 64KB or 128KB

Memory dump file setting

Set up the memory dump file according to the following procedures.
1
Log on to the server with the administrator account.
2
Check the free space of the drive where the memory dump file is to be stored.
Check the required free space according to "
If the drive has insufficient free space, refer to "
3
Display the [System Properties] window.
For Windows Server 2008
1. Click [Start] – [Control Panel].
Control Panel appears.
2. Double-click the [System] icon.
System Control Panel appears.
3. From the tasks, select [Advanced system settings].
The [System Properties] window appears.
For Windows Server 2003
1. Click [Start] – [Control Panel] – [System].
The [System Properties] window appears.
PRIMERGY RX600 S4 User's Guide
Checking hard disk free space" ( pg.74).
Cannot collect the memory dump" ( pg.202).
75