Automatic Driver Installation With Serverstart - Fujitsu Primergy RX300 S4 User Manual

Chapter 2 Checking before OS Installation
Adapter numbers
For ServerStart, onboard multiple LAN adapters (network adapter) may be configured on OS
installation wizard.
To configure multiple LAN cards, select the adapter numbers in order of Adapter 1 and Adapter 2, and
enter settings for each adapter. Note that the order of adapter numbers is not necessarily the same as the
order of slots for the installed LAN adapters. This means that the setting for Adapter 1 is not always
applied to the onboard LAN. After installing the OS, check the LAN adapters to make sure that they are
configured as intended.
Setting up the printer
ServerStart does not support setup of printers. Perform installation after setup is completed.

2.3.4 Automatic Driver Installation with ServerStart

ServerStart supports automatic driver installation for the following expansion cards.
Onboard controller/Card type
Onboard FDD/IDE
Onboard LAN
Onboard VGA
SAS RAID Ctrl
SAS Ctrl
Eth. Ctrl 1000-BASE-SX Fibre LC lp
Eth. Ctrl 1000-BASE-T Cu lp
Eth. Ctrl 1x1Gbit PCI 1000-BASE-T lp
Eth. Ctrl 2x1Gbit PCI-X 1000-BASE-T lp
Eth. Ctrl 1x1Gbit PCI-E 1000-BASE-T lp
Eth. Ctrl 1x1Gbit PCI-E 1000BASE-SX lp
Eth. Ctrl 2x1Gbit PCI-E 1000-BASE-T lp
SCSI Ctrl U320 lp
Fibre Channel Controller
48
table: Automatic Driver Installation
-
-
-
PG-248G2L/PG-248CL/
PG-244CL
PG-228BL
PG-1882L
PG-1892L
PG-1853L
PG-1863L
PG-289L
PG-288L
PG-2861L
PG-2281L
PG-FC202
Product ID Bus
-
PCI-E
PCI
PCI-E
PCI-E
PCI-X
PCI-X
PCI-X
PCI-X
PCI-E
PCI-E
PCI-E
PCI-E
PCI-E