Chapter 6 Installing Internal Options
For USB device
Connect the USB cable to the USB connecter of the baseboard. For the USB connecter location,
refer to "1.3.4 Baseboard" ( pg.28).
11
Attach the upper processor air baffle.
Insert the notches on the front side of the baffle into the front of the server.
Pass the cable through the sides of the baffle. At this time, make sure that the cable is not
pinched.
Seen from the back
Insert the notches of the
air baffle in the tabs on the
front side of the server.
152
Notches
USB connector