Fujitsu 1PRIMERGY RX600 S4 User Manual page 231

3
When "Please enter pass phrase:" appears, enter the password, and press the
[Enter] key.
Note that the password is case-sensitive. As shown below, the characters you have entered are
displayed as asterisks.
Please enter pass phrase: ******
The remote control main menu appears.
****************************************
* Welcome to PRIMERGY Remote Manager
* Firmware Revision x.xxA (x.xx)
* SDRR *.** ID 0203
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type : PRIMERGY RX600 S4
System ID : xxxxxxxx
System Name : RX600S4-2 (xxx.xxx.xxx.xxx)
System OS : xxxxxxxx
System Status: OK
Power Status : On
Main Menu
(1) System Information...
(2) Power Management...
(3) Enclosure Information...
(4) Service Processor...
(c) Change password
(r) Console Redirection (EMS/SAC)
(s) Start a Command Line shell...
Enter selection or (0) to quit:
4
Press the [2] key, and select "Power Management".
The [Power Management] menu appears.
****************************************
* Welcome to PRIMERGY Remote Manager
* Firmware Revision x.xxA (x.xx)
* SDRR *.** ID 0203
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type : PRIMERGY RX600 S4
System ID : xxxxxxxx
System Name : RX600S4-2 (xxx.xxx.xxx.xxx)
System OS : xxxxxxxx
System Status: OK
Power Status : On
Power Management Menu
(1) Immediate Power Off
(2) Immediate Reset
(3) Power Cycle
(*) Power On
(*) Graceful Power Off (Shutdown)
(*) Graceful Reset
Enter selection or (0) to quit:
*
*
RX600S4 *
*
*
RX600S4 *
(Reboot)
PRIMERGY RX600 S4 User's Guide
231