For Windows Server 2003 - Fujitsu 1PRIMERGY RX600 S4 User Manual

Chapter 8 Operation and Maintenance
7
Click [Finish].
The restoration start window appears.
8
Check the checkbox, and click [OK].
System restoration starts.
After the restoration has completed, the system is automatically rebooted. After rebooting, the
system is restored using the backup data.

8.6.2 For Windows Server 2003

Items required
• Windows Server 2003 CD/DVD (Installation disc)
• Automated System Recovery (ASR) floppy disk (created beforehand)
• Backup media (created beforehand)
• Driver disk (for an array controller)
For details on required driver disk and how to create a driver disk, refer to "4.4 Creating
Maintenance Tools and Driver Disks" ( pg.87).
Before turning on the server, connect a USB floppy disk drive. For details, refer to "Appendix C
External Floppy Disk Drive (USB) Notes on Usage" ( pg.227).
1
Turn on the server, and insert the Windows Server 2003 CD/DVD (Installation
disc) immediately.
Check that no floppy disk is inserted.
2
When the active area is specified on the hard disk, the following message
appears. Press any key while this message is displayed.
Press any key to boot from CD....
Setup window for Windows Server 2003 appears.
3
The following message appears at the bottom of the window. Press the [F6]
key.
Press F6 if you need to install a third party
SCSI or RAID driver ...
214
For operation with a BitLocker drive encryption set, perform the encryption settings again after
the system restoration.
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.