To Enable Ils - Christie CP2000-M Setup Manual

Section 2: Basic Operation
:

To enable ILS

1. From the Main menu select 1 of
the available channels.
2. Enable Test Patterns to bring up a
test pattern.
3. Select the ILS button from the
Main menu to launch the ILS
screen.
 Select Automatic ILS to
automatically apply the per
channel settings.
To edit active channel ILS settings:
1. Ensure Automatic ILS is checked.
2. Adjust the focus, horizontal (X) and vertical (Y) offset or zoom one step at a time by clicking the
applicable button or hold the button down for continuous movement. If you hold a cutton down, a
pending message will display ntil you release the button. NOTE: This over-writes the intelligent
lens system settings.
To temporarily alter the active channel ILS settings:
1. De-select the Automatic ILS checkbox.
2. Adjus the focus, horizontal (X) and vertical (Y) offset, and zoom. Note: This does not over-write
the system settings for the ILS.
3. To revert back to the ILS settings, check Automatic ILS.
Start Features or Presentations
display Channel button. NOTE: By clicking a channel button, test patterns and automatically turned
OFF to present show content.
2-18
F
IGURE
To start a different feature or presentation, click its corresponding
2-10 I L S
NTELLIGENT ENS
CP2000-M/MR Setup Guide
YSTEM
020-100205-03 Rev. 1 (05/09)