Admin: Screen Menu; Summary Of Admin: Screen Menu - Christie CP2000-M Setup Manual

2.13.2 Admin: Screen Menu

The Admin: Screen menu defines what portion of the projector's display panel to use and what
cropping is needed to disguise possible keystoning or other geometric aberrations. Once saved, a
screen file can be used with any incoming source as desired—screen data is not included in a PCF and
is independent of source settings. Consider screen files as convenient compensations for physical
limitations in the environment. Typically, 1 or 2 screen files per site are needed.
A Cropping: Crop corners and sides
B Presentation: Select a reference point used
to define screen display area
C
Screen: Select screen type from drop-down
D Save

Summary of Admin: Screen Menu

• Presentation: Presentation points define the display size and location. Default = Full 2048 x 1080
panel. Presentation points define what region of the projector's available display area responds to
incoming data. By default, the projector uses its complete display area, scaling the incoming data as
necessary. If, for some reason, you want to limit the display area, enter the desired upper left and
lower right presentation coordinates (or adjust with slidebars). You can define a smaller
rectangular area in which the left and right top corners always share the same Y-coordinate (as will
the left and right bottom corners), and the top and bottom left corners share the same X-coordinate
(as will the top and bottom right corners). Thus upper right and lower left coordinates are not
available to define the area. Incoming data automatically resizes to fill the reduced rectangular area
defined by the new coordinates and any display pixels outside of this area remain OFF (black).
• Cropping: Cropping hides unwanted data, useful if the image appears keystoned, etc. Cropping is
the digital equivalent of filling aperture plates in a film projector to perfect the image "square-ness".
For example, if the bottom of the image appears slightly wider than the top, activate the bottom left
CP2000-M/MR Setup Guide
020-100205-03 Rev. 1 (05/09)
F 2-13 A : S
IGURE DMIN CREEN
E Restore: Cancel unsaved screen settings &
display previous saved settings
F Letter Box: Enable to display all incoming data
within the defined presentation area
G
XY: Define new display area and/or cropping
H Lens Factor: Define anamorphic lens used to
stretch an image horizontally
Section 2: Basic Operation
M
ENU
2-23