Install Lens - Christie CP2000-M Setup Manual

4.3.2 INSTALL LENS

1. Remove the small rear cap.
2. Align the mounts on the lens connector with
the lens mount. Insert the lens until it connects
with the magnets on the mount. Once the lens
makes contact with the magnetic plates it will
be seated correctly and the connector for
motorized zoom and focus will be properly
connected (Figure 4-5).
3. For added stability, secure the capscrews
provided on the lens-mount. If you have
installed a large zoom lens, 1 or more of the
screws may be inaccessible. Simply tighten
those that are accessible.
NOTE: Recommended for heaviest lenses,
such as 0.8:1 and 1.3-1.75:1.
CP2000-M/MR Setup Guide
020-100205-03 Rev. 1 (05/09)
Section 4: Maintenance
F 4-5 I L
IGURE NSTALL ENS
4-5