Status Menu - Christie CP2000-M Setup Manual

Section 2: Basic Operation
2.8

STATUS MENU

There are 3 status LEDs on the CDP for the purpose of indicating
projector status. Table 2.3 details the various conditions and
meanings of the LEDs. In addition to the visual indicator of the
LEDs, the status of specific projector components can be checked
through the CDP Status menu (Figure 2-7). The Status menu
provides status information on various projector components. These
menu features are also available via the web ui Status:System
menu. For information, refer to the CP2000-M/MR User Manual
(020-100123-xx).
Table 2.2 Status LEDs: Indicating Projector Status
ON
(GREEN)
/
Flashing
Flashing
Solid Green
Solid Green
ON or OFF
ON or OFF
If the projector encounters a system error or malfunction, the red
to display the alarm message on the CDP display and acknowledge that the message has been
ENTER
seen. The
ERROR
error is encountered by the projector. If a safety interlock, content security lock or DMD over-
temperature fault occurs during operation, the
automatically turns OFF and the Lamp button is disabled until the problem is fixed.
2-14
READY ERROR
(YELLOW) (RED)
Solid Yellow /
Solid Yellow /
Flashing /
Solid Yellow /
/ /
ON or OFF Flashing
Red
ON or OFF Solid Red
LED turns a solid red and remains in this state until the problem is resolved or a new
DESCRIPTION
Power is OFF, lamp is OFF. Projector is in STANDBY mode.
Warming up.
Lamp COOL DOWN mode - approximately 15 minutes.
Power is ON, but lamp is not turned ON.
Power is ON, lamp is ON.
New alarm condition detected (such as critical warning
detected by DMD temperature sensors). Press
acknowledge error.
Alarm condition exists, but has been acknowledged in the web
user interface or CDP.
ERROR
LED illuminates; however, power to the lamp
ERROR
F 2-7 S M
IGURE TATUS ENU
to
ENTER
LED begins flashing. Press
CP2000-M/MR Setup Guide
020-100205-03 Rev. 1 (05/09)