Controls - Polycom VSX 3000 Administrator's Manual

Administrator's Guide for the VSX Series
Symptom
The system does not power
off when you press and
hold the power switch.
(VSX 7000e, VSX 8000)

Controls

Symptom
The system does not
respond to the remote
control.
The monitor screen
remains blank when you
pick up the remote control.
The remote control does
not work in voice-only calls
using the
SoundStation VTX 1000
conference phone.
7 - 10
Problem
The power switch is bad.
Problem
No, low, or dead batteries
in the remote control.
The batteries are installed
incorrectly in the remote
control.
The room lights operate in
the 38 Khz range and
interfere with the remote
control signals.
The infrared sensor is not
receiving signals from the
remote control.
VSX 8000:
The external infrared
sensor is not operating
properly.
The monitor's power cord is
not plugged in.
The monitor is powered off.
The monitor is not
connected correctly to the
system.
This is normal.
Corrective action
Return the system for service.
Corrective action
Install three AAA batteries in the remote control.
Insert the batteries in the correct +/- position.
Turn off the lights in the room and try the remote
control again.
Make sure the transparent protective strip has been
removed from the infrared sensor on the front of the
system.
Make sure you are pointing the remote control at the
infrared sensor on the front of the system or the
camera.
Check the connections between the rear panel, cable
adapter, and infrared sensor cable.
Connect the monitor's power cord and then power on
the monitor.
Power on the monitor.
Verify that the monitor is connected correctly
according to the manufacturer's instructions and the
setup sheet you received with the system.
Use the SoundStation VTX 1000 conference phone
controls in voice-only calls.