Polycom VSX 3000 Administrator's Manual page 78

Administrator's Guide for the VSX Series
3 - 24
Setting Description
Enable Allows the system to make calls through your third-party
V.35/RS-449/ network equipment.
RS-530
This selection is only available when the system has a
VSX 7000 V.35/RS-449/RS-530 network module installed.
VSX 7000s
VSX 7000e
VSX 8000
Enable Analog Allows the system to make voice-only calls to any phone using
Phone an analog phone line.
VSX 7000e Disable this setting to remove a SoundStation VTX 1000
VSX 8000 conference phone from the dialing order.
3. Select to go to the Network Dialing screen and specify the Dialing
Order preference for the available choices.
Dialing Order specifies how the system places calls to directory entries
that have both IP and ISDN numbers. It also specifies how the system
places calls dialed manually when the call type selection is either
unavailable on the home screen or set to Auto. If a call attempt does not
connect in this case, the system tries to place the call using the next call
type in the Dialing Order.
If the call type on the home screen is set to a specific call type, the system
does not attempt to place the call using a different call type, even if other
types are listed in the Dialing Order.
4. Select to go to the Preferred Speeds screens and configure these
settings:
Setting Description
Preferred Speed Determines the speeds that will be used for calls from this
for Placing Calls system when:
•
•
If the far-site system does not support the selected speed, the
system automatically negotiates a lower speed.
Maximum Speed Allows you to restrict the bandwidth used when receiving
for Receiving calls.
Calls
If the far site attempts to call the system at a higher speed
than selected here, the call is re-negotiated at the speed
specified in this field.
5. Select to go to the Call Speeds screen and specify the call speeds to
make available to users, if you are allowing them to choose speeds on a
call-by-call basis.
Call Quality is set to Auto on the home screen and
Directory screen, or
The Call Quality setting is not available for users.