Sp Mode Tables; Sp4-Xxx (Mode) - Ricoh B867 Manual

SP Mode Tables

4.2 SP MODE TABLES
The tables in this section list the service programs (SPs).
The following codes are used:
Asterisk (*): The settings are saved in the NVRAM. Most of them return to the default
values when you execute SP 5801 2.
CTL indicates that the data is contained in the NVRAM on the controller board.
The DFU menu is for design or factory use only. You must not change the settings.
Brackets ([ ]): The brackets enclose the setting rage, default value, and minimum step
(with unit) as follows: [Minimum to Maximum / Default / Step].
SSP: Consult your supervisor before you use this program.

4.2.1 SP4-XXX (MODE)

4921* [Image Adj Selection]
Copy
Selects which mode the settings from SP4-922 to SP4-932 are used for.
001
0 = None, 1 = Text 1, 2 =Text 2, 3= Photo 1, 4 = Photo 2, 5 = Photo 3, 6 =
Special 1, 7 = Special 2, 8 = Special 3, 9 = Special 4,
10 = Special 5
Fax
002 Selects which mode the settings from SP4-922 to SP4-932 are used for.
0 = None, 1 = Text 1, 2 = Text 2, 3 = Photo 1, 4 = Photo 2,
5 = Special 1
Scanner
003
Selects which mode the settings from SP4-922 to SP4-932 are used for.
0 = None, 1 = Text 1, 2 = Text 2, 3= Photo 1, 4 = Photo 2
[Scanner Gamma]
4922*
Selects "text" or "photo" as the priority output mode. This setting is applied to
all image processing modes of SP4-921.
B867
[0 to 10 / 0 / 1]
[0 to 5 / 0 / 1]
[0 to 4 / 0 / 1]
38 SM