Ricoh B867 Manual page 132

Using SP Mode
1. Turn off the main power switch.
1. If the machine is connected to a network, disconnect the network cable from the
copier.
2. Remove the slot cover [A] ( x 1)
3. With the label on the SD card facing the rear side of the machine, insert the SD card
into the upper slot [B] on the controller box. Slowly push the SD card into the slot so it
locks in place.
4. Make sure the SD card is locked in place.
(To remove the SD card, push it in to unlock the spring lock and then release it so it
pops out of the slot.)
5. Switch the main power switch on. After about 5 seconds, the LCD will display "Please
wait..." Then, about 60 seconds later, the LCD will display "Program UpDate Menu
P.01" on the first line and the name of the firmware on the second line (e.g.
System/Copy).
6. Press the "OK" key to select a module.
B867 122 SM