Ricoh B867 Manual page 135

Code Cause
E22 Decompression error
E23 Update program error
E24 SD card access error
Download data
E31
inconsistency*
Download data
E32
inconsistency*
E33 Version data error
E34 Locale data error
Machine model data
E35
error
E36 Module data error
Engine program
E40
error**
Operation panel
E42
program error*
Controller program
E44
error*
E50 Authentication error
*You need to reinstall the program.
If the firmware update program is interrupted (for example, by a power failure), keep the SD
card inserted and turn the mains switch off and on. The firmware update program restarts.
If you do not do so, the message "Reboot after Card insert" is displayed when you turn the
main switch on.
SM
Necessary Action
Store correct data in the SD card.
Update controller program.
Replace the controller.
Insert the SD card correctly.
Use another SD card.
Insert the SD card that was used when the previous
update procedure is interrupted.
Insert the SD card that stores the correct data.
Store the correct data in the SD card.
Store the correct data in the SD card.
Store the correct data in the SD card.
Store the correct data in the SD card.
Store the correct data in the SD card.
Replace BICU.
Store the correct data in the SD card.
Replace the operation panel board.
Store the correct data in the SD card.
Replace the controller board.
Store the correct data in the SD card.
125
Using SP Mode
B867