Firmware Update Procedure - Ricoh B867 Manual

Using SP Mode
4. To view more information, select "Detail."
Jam History Code
Code Meaning
210 Original does not reach the registration sensor.
211 Original caught at the registration sensor.
212 Original does not reach the original exit sensor.
213 Original caught at the original exit sensor.
214 Original does not reach the original reverse sensor.
215 Original caught at the original reverse sensor.

4.5.6 FIRMWARE UPDATE PROCEDURE

This section illustrates how to update the firmware of the machine (the machine with the
optional controller box).
To update the firmware for the machine, you must have the new version of the firmware
downloaded onto an SD (Secure Digital) Card. The SD Card is inserted into the uppermost
slot on the right side of the controller box, viewed from the back of the machine.
Before You Begin...
An SD card is a precision device, so always observe the following precautions when
handling SD cards:
Always switch the machine off before inserting an SD card. Never insert the SD card
into the slot with the power on.
When the power is switched on, never remove the SD card from the service slot.
Never switch the machine off while the firmware is downloading from the SD card.
Store SD cards in a safe location where they are not exposed high temperature, high
humidity, or exposure to direct sunlight.
Always handle SD cards with care to avoid bending or scratching them. Never drop an
SD card or expose it to other shock or vibration.
Keep the following points in mind while you are using the firmware update software:
"Upload" means to send data from the machine to the SD card, and "download" means
to send data from the SD card to the machine.
B867 120 SM