Ricoh B867 Manual page 14

Controller Box and Printer/Scanner
6. Attach the ferrite core [E] to the network cable [F]. The end of the ferrite core must be
about 8 cm (3.2") from the end of the cable [G].
Install the ground cable [H] as shown, and then clamp the cable ( x 2,  x 1).
7.
8. Release the clamps [I], and then bind the harness [J] with the clamp [K].
9. Attach the clamp [K] to the controller box.
10. If you do not install the FCU, reinstall the FCU bracket (which has been removed in
Step 1 Item 7), to the controller box.
B867 4 SM