Ricoh B867 Manual page 134

Using SP Mode
8. The firmware update program starts and the message "Loading" is displayed.
The update will begin, and then will take a few minutes to complete. The LCD will
initially display, "Updating...
When the update is completed, the LCD display will change to "Update done" or
"Updated / Power Off On".
9. Check that the message "Update Done" is displayed.
Confirmation
1. Turn the main power switch off and on.
The LCD will display "Please wait..." for about 60 seconds, after which it will return
to the "Program UpDate Menu" screen.
2. Repeat Steps 1-8 above until all firmware updates are complete.
3. Turn the main power switch off.
4. Remove the SD card from the lower slot on the controller by pushing on the card to
release the spring lock.
If an error occurs, the error code is displayed. For a list of information on error codes, see
the following table.
Code Cause
Physical address
E20
mapping error
B867
***---------".
Necessary Action
Insert the SD card correctly.
Use another SD card
124 SM