Ricoh B867 Manual page 54

SP Mode Tables
001 This program disables copying.
5120* [Clr For Cnt Remove] CTL
Determines under which conditions the copy job settings are reset when the
key counter is removed. With 0, the settings are cleared if the counter is
removed at the end of a job or midway through a job. With 1, they are only
001
cleared if the counter is removed at the end of a job. With 2, they are not
cleared at all, under either condition. With duplex copies, the job settings are
always preserved, regardless of the setting of this SP mode.
5121* [Counter Up Timing]
Selects whether the key counter increments at time of paper feed-in or at time
001
of paper exit.
5127 [APS Mode]
001 This program disables the APS.
5150 [By-pass Long Paper]
Determines whether the transfer sheet from the by-pass tray is used or not.
001 Normally the paper length for sub scanning paper from the by-pass tray is
limited to 600 mm, but this can be extended with this SP to 1260 mm.
[Fax Printing Cnt Off]
Enables or disables the automatic print out without an accounting device. This
5167
SP is used when the receiving fax is accounted by an external accounting
device.
Fax Printing Counter
001
Off
B867
[0=Yes / 1=Standby only / 2=No]
CTL [0 = Feed In / 1 = Exit]
CTL [0: Not disabled/ 1: Disabled]
CTL [0 = Feed In / 1 = Exit]
[ 0 or 1 / 0 / – ]
CTL 0: Automatic printing
1: No automatic printing
44 SM