Serial Number Input (Sp5-811) - Ricoh B867 Manual

Use SP5-998-001 after you have replaced the BICU NVRAM or when the BICU NVRAM
data is corrupted. When the program ends normally, the message "Completed" is displayed.
When you have replaced the controller NVRAM or when the controller NVRAM data is
corrupted, use SP5-801-001. The message is the same as the basic machine.
Memory Clear Procedure
1. Print out all SMC data lists (
2. Do SP5-998-001.
3. Press the OK key.
4. Select "Execute." The messages "Execute?" followed by "Cancel" and "Execute" are
displayed.
5. Select "Execute."
6. When the program has ended normally, the message "Completed" is displayed. If the
program has ended abnormally, an error message is displayed.
7. Turn the main switch off and on.
8. Adjust the printer and scanner registration and magnification (
the chapter "Replacement and Adjustment").
9. Refer to the SMC lists, and enter any values that differ from the factory settings.
Double-check the values for SP4-901.
10. Adjust the standard white level (SP4-428).
11. Initialize the TD sensor (SP 2-214).
12. Check the copy quality and the paper path.

4.5.2 SERIAL NUMBER INPUT (SP5-811)

Specifying Characters
SP5-811-001 specifies the serial number. For the machine with the optional controller, you
use the numeric keypad and the optional operation panel.
Network Enabled Machine
You can use the numeric keypad to type numbers. In addition, you can use the operation
panel to type other characters. When you press the "ABC" key, the letter changes as
follows: A → B → C. To input the same letter two times, for example "AA," you press the
"ABC" key, the "Space" key, and the "ABC" key. To switch between uppercase letters and
lowercase letters, press the "Shift" key.
Serial Number and NVRAM
Serial numbers are stored in the NVRAM before shipment and are not cleared. You must
specify a serial number after you replace the NVRAM.
SM
"SMC Print").
117
Using SP Mode
"Copy Adjustment" in
B867