Priority Scanning (P-Scan); Preset Channels ( 0 ~ 9 ) : Instant Access; Programming - Standard Horizon MATRIX AIS/GPS GX2200E Owner's Manual

7.8.4 Priority Scanning (P-SCAN)

In the default setting, Channel 16 is set as the priority channel. You may
change the priority channel to the desired channel from Channel 16 by the
General Setup mode, refer to section "10.5 PRIORITY CHANNEL".
1. Adjust the SQL knob until background noise disappears.
2. Press one of the soft key, then press the
soft key. " P-SCAN " appears on the display. Scan-
ning will proceed between the memorized chan-
nels and preset channel (described in next
section) and the priority channel.
The priority channel will be scanned after each programmed channel.
3. To stop scanning, press the

PRESET CHANNELS ( 0 ~ 9 ) : INSTANT ACCESS

7.9
10 preset channels can be programmed for instant access. Press one of the
soft keys, then press the
the user assigned channel bank. If the
channels have been assigned, an alert beep will be emitted from the speak-
er.
Before beginning the Instant Access operation, assign the "PRESET"
command into one of the programmable keys, refer to section "9.10 SOFT
KEYS".

7.9.1 Programming

1. Rotate the CH knob to select the channel to be
programmed.
2. Press one of the soft keys to indicate the function
on the display, then press and hold the
soft key until the channel number blinks.
3. Rotate the CH knob to select the desired preset
channel position (" SET 0 " - " SET 9 ") you wish to
program.
4. Press the
into the preset channel.
5. Repeat steps 1 through 4 to program the desired channels into the
preset channels "0" ~ "9".
Page 38
or
16
9
soft key. Pressing the
PRESET
soft key to program the channel
50 37.660
000 55.989
key.
CLR
WX
PRESET
soft key is pressed and no
PRESET
50 37.660
000 55.989
PRESET
50 37.660
000 55.989
50 37.660
000 55.989
25.0
123
12:56
key activates
0
25.0
123
25.0
123
06
25.0
123
12:56
GX2200E