Standard Horizon MATRIX AIS/GPS GX2200E Owner's Manual page 73

DSC Position Report Call Manually Entering an MMSI
This feature allows you to send your position to another vessel by manually
entering the MMSI of the ship you want to send your position to.
1. Press the
appear.
2. Rotate the CH knob to select " POS REPORT ".
(To cancel, press the
3. Press the
will beep, and the POS report call menu will
appear.
4. Rotate the CH knob to select " MANUAL ",
then press the
5. Rotate the CH knob to select the first
number of the MMSI which you want to
contact, then press the
step to the next number.
6. Repeat step 5 to set the MMSI number.
If a mistake was made entering in the MMSI
number, repeatedly press the
key until the wrong number is selected,
then rotate the CH knob to correct the entry.
7. When finished entering the MMSI number,
press and hold the
8. Rotate the CH knob to select the nature of
call (" ROUTINE " or " SAFETY "), then press the
soft key.
9. Press the
10. Press the
" SAFETY " is normally used as the category for position report calls.
However, " ROUTINE " should be selected when calling a vessel with
radios of certain legacy models that cannot accept position report
calls categorized as " SAFETY ".
GX2200E
key. The " DSC Menu " will
CALL
MENU
soft key.)
soft key. The transceiver
soft key.
soft key.
soft key to send your position to the selected vessel.
soft key to return to radio operation.
Input MMSI
ID:---------
SELECT
soft key to
soft
Category:Routine
NOTE
-POS Report Call-
-POS Report Call-
BACK QUIT
Input MMSI
ID:345678901
SELECT BACK
-POS Report Call-
Name:
ID:345678901
Category:Routine
Transmit?
YES
-POS Report Call-
Name:
ID:345678901
Transmiting
QUIT
QUIT
Page 73