Priority Scanning (P-Scan) - Standard Horizon MATRIX GX3000S Owner's Manual

10.12.3 Priority Scanning ( P-SCAN )
In the default setting, Channel 16 is set as the priority channel. You may change
the priority channel to the desired channel from the Channel 16 by the Radio
Setup Mode, refer to section "12.6 PRIORITY CHANNEL SET."
1. Adjust the SQL knob until background noise disappears.
2. Select a desired channel to be scanned using the
CHANNEL selector knob. Press and hold the
[ SCAN ( MEM )] key for one second, "MEM" will ap-
pear on the display which indicates the channel has
been programmed into the transceivers memory.
3. Repeat step 2 for all the desired channels to be scanned.
4. To DELETE a channel from the transceiver's memory, select the channel
then press and hold the [ SCAN ( MEM )] key until "MEM" is removed from
the display.
5. To start priority scanning, press the [ SCAN ( MEM )]
key momentarily. "
Scanning will proceed between the memorized chan-
nels and the priority channel. The priority channel
will be scanned after each programmed channel.
6. To stop scanning, press the [ 16/9 ] or [ WX ] key.
You may change the scan resume time in the Radio Setup Mode, refer to
section "12.8 SCAN RESUME TIME."
Page 30
P-SCAN P-SCAN " appears on the LCD.
P-SCAN P-SCAN P-SCAN
GX3000S