Intercom Operation; Communication; Calling - Standard Horizon MATRIX AIS/GPS GX2200E Owner's Manual

7.11 INTERCOM OPERATION

An optional RAM3 (CMP30) must be connected to perform intercom func-
tions between the radio and the RAM3 (CMP30).
In addition, to access the following intercom functions one of the soft keys
must be setup as

7.11.1 Communication

1. Press one of the soft keys, then press the
soft key to enable the intercom mode.
Note: Depending on the programming of the
soft key, the
be pressed to see the
2. When the intercom mode is enabled, " Intercom " is displayed on the
radio and RAM3.
3. Press the PTT switch on the
radio. " Talk " will be shown
on the display.
Note: A warning beep will
be heard when the radio's
P T T a n d R A M 3 ' s P T T
switches are pushed at the
same time.
4. Speak slowly and clearly
into the microphone, hold
t h e m i c r o p h o n e a b o u t
1 . 5 c m a w a y f r o m y o u r
mouth.
5. When finished, release the PTT switch.
6. Press the

7.11.2 Calling

Pressing and holding the
the radio or RAM3 microphone will produce a calling beep to the other
station.
GX2200E
. Refer to section "9.10 SOFT KEYS".
soft key may have to
key to exit intercom mode and revert to radio mode.
CLR
WX
soft key.
GX2200E
50 37.660
000 55.989
12:56
( GX2200E's PTT switch is pressed )
GX2200E
50 37.660
000 55.989
12:56
( RAM3's PTT switch is pressed )
soft key when in intercom mode on either
50 37.660
000 55.989
12:56
RAM3
50 37.660
000 55.989
12:56
RAM3
50 37.660
000 55.989
12:56
Page 43