Standard Horizon MATRIX AIS/GPS GX2200E Owner's Manual page 58

6. Press the
CH knob to select the operating channel
you want to communicate on, then press
the soft key.
7. Press the
individual DSC signal.
8. When an individual call acknowledgment is
received, the established channel is auto-
matically changed to the channel which is
selected on step 6 above and a ringing tone
sounds.
9. Press the
channel to make sure it is not busy, then
press the microphone's PTT switch and talk
into the microphone to the other vessel.
Individual Call by Manually Entering a MMSI
You may enter an MMSI number manually to contact without storing it in the
individual directory.
1. Press the
appear.
2. Rotate the CH knob to select " INDIVIDUAL ".
(To cancel, press the
3. Press the
will beep, and the last individual calls will
appear.
4. Press the
MANUAL
" " with the CH knob.
5. Press the
6. Rotate the CH knob to select the first
number of the MMSI which you want to
contact, then press the
step to the next number.
7. Repeat step 6 to set the MMSI number (nine digits).
If a mistake was made entering in the MMSI number, repeat pressing
the key until the wrong number is selected, then rotate the CH
knob to correct the entry.
8. When finished entering the MMSI number, press and hold the
soft key.
Page 58
soft key, then rotate the
soft key to transmit the
soft key to listen to the
key. The " DSC Menu " will
CALL
MENU
soft key. The transceiver
soft key, then select
soft key.
soft key.)
soft key to
-Individual Call-
Input MMSI
ID:---------
SELECT BACK
-Individual Call-
Input MMSI
ID:345678901
QUIT
SELECT BACK
QUIT
GX2200E