Programming The Mmsi - Standard Horizon MATRIX AIS/GPS GX2200E Owner's Manual

8.2.2 Programming the MMSI

The MMSI can be inputted only once. Therefore please be care-
ful not to input the incorrect MMSI number. If you need to change
the MMSI number after it has been entered, the radio will have to be
returned to Factory Service. Refer to the section "17.2 FACTORY
SERVICE."
1. Press and hold the
Menu " appears.
2. Rotate the CH knob to select " MMSI SETUP ".
3. Press the
the soft key.)
4. Rotate the CH knob to select the first
number of your MMSI, then press the
soft key to step to the next number.
5. Repeat step 4 to set your MMSI number
(nine digits).
6. If a mistake was made entering in the MMSI
number, press the
wrong number is selected, then rotate the
CH knob to correct the entry and press the
soft key.
7. When finished programming the MMSI
number, press and hold the
The radio will ask you to input the MMSI
number again. Use steps 4 through 6
above.
8. After the second number has been input,
press and hold the CH knob to store the
MMSI.
9. Press the
operation.
To view your MMSI after programming to ensure it is correct, perform
steps 1 to 3. Look that the MMSI number shown on the display is
correct.
GX2200E
WARNING
key until " Setup
CALL
MENU
soft key. (To cancel, press
soft key until the
soft key to return to radio
NOTE
-User MMSI-
Input User MMSI
---------
ENT
-User MMSI-
Input User MMSI
*********
Input Again
---------
ENT
soft key.
BACK QUIT
-User MMSI-
Input User MMSI
123456789
ENT BACK QUIT
-User MMSI-
Input User MMSI BACK QUIT
*********
Input Again
123456789
ENT BACK QUIT
-User MMSI-
Stored ID
123456789
OK
Page 47