Receiving A Dsc Distress Call - Standard Horizon MATRIX AIS/GPS GX2200E Owner's Manual

Canceling a DSC Distress Call
If a DSC distress call was sent by error the GX2200E allows you to send a
message to other vessels to cancel the distress call that was made.
Press the

8.3.2 Receiving a DSC Distress Call

1. When a DSC distress call is received, an emer-
gency alarm sounds.
2. Press any key to stop the alarm.
3. The display shows the position of the vessel in
distress. To show additional information of the
vessel in distress, rotate the CH knob counter
clockwise (refer to the second display).
On the display you will notice 3 soft key selections. These selections are
described below:
: Press this key to accept the DSC distress call and to switch to
Channel 16.
Note: If a key is not pressed for 10 seconds or longer the radio will auto-
matically select Channel 16.
: Press this key to temporarily disable automatic switching to
Channel 16.
: Press this key to quit the automatic Channel 16 switching and
revert to the last selected working channel.
4. Press the
Input " menu, then enter the desired waypoint
name (up to 11 characters), described previously
(select the letter/number by rotating the CH knob
and move the cursor by pressing the
/ soft keys).
The ID is the MMSI from the vessel in distress.
GX2200E
soft key, then press the
50 37.660
000 55.989
10:00
02:25
soft key to enter the " Waypoint
soft key.
123456789
01:03
50 35.846
001 01.623
10:00
12.3
163
123456789
01:03
Page 51