Nmea Data In/Out; Key Beep - Standard Horizon MATRIX AIS/GPS GX2200E Owner's Manual

9.6

NMEA DATA IN/OUT

This menu is used to setup the NMEA 0183 baud rate of the GPS input (Blue
and Green wires) and DSC output (Gray and Brown wires). The default
setting is 4800 bps.
When 38400 bps is selected the AIS sentences (VDM) and DSC sentences
(DSC & DSE) both are output on the Yellow and White wires after a DSC
distress, position request or AIS transmission is received.
1. Press and hold the
appears.
2. Rotate the CH knob to select " GENERAL SETUP "
menu.
3. Press the
knob to select " NMEA DATA IN/OUT ".
4. Press the
5. Rotate the CH knob to select the desired baud
rate.
6. Press the
setting.
7. Press the
radio operation.
9.7

KEY BEEP

This selection is used to select the beep tone volume level when a key is
pressed.
1. Press and hold the
appears.
2. Rotate the CH knob to select " GENERAL SETUP "
menu.
3. Press the
knob to select " KEY BEEP ".
4. Press the
5. Rotate the CH knob to select the desired level.
The beep level can be set from " LEVEL 1 " to
" LEVEL 6 ", " HIGH ", or " OFF ".
6. Press the
level.
7. Press the
radio operation.
GX2200E
key until " Setup Menu "
CALL
MENU
soft key, then rotate the CH
soft key.
soft key to store the new
soft key two times to return to
key until " Setup Menu "
CALL
MENU
soft key, then rotate the CH
soft key.
soft key to store the selected
soft key two times to return to
-Key Beep-
HIGH
Level 6
Level 5
Level 4
Level 3
Level 2
ENT QUIT
Page 91