Icom IC-M71 Instruction Manual page 156

CONTAINERIZED KITCHEN (CK)
UNIT MAINTENANCE PROCEDURES
HAND SINK ASSEMBLY
THIS SECTION COVERS:
Inspect, Test, Replace
INITIAL SETUP:
CK set up for operations
Water pump and water heater connected to the Appliance Control Box
Water supply hose connected
Drain hose connected
Maintenance Level
Unit
Tools and Special Tools
Tool Kit, General Mechanic's (WP 0052 00, Table 1, Item 1)
GENERAL
This procedure contains information and instructions for inspecting and repairing the Hand Sink
Assembly. Refer to WP 0041 00 for repair parts information.
Disconnect the pump and water heater power cables from the Appliance
Control Box before making any repairs to the sink assembly.
The water in the hot water tank may be hot. Allow the water to cool before
opening the drain valve.
INSPECT
Inspect water connections for leaks at the pump head, in the area around the water heater, and
the faucet above and below the sink. Inspect electrical connectors and cords for damage.
Inspect the water supply hoses and interior drain hose for damage, missing or damaged
washers or gaskets.
TM 10-7360-226-13&P
WARNING
WARNING
0024 00-1
0024 00