Icom IC-M71 Instruction Manual page 126

TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (CK) 0017 00
UNIT MAINTENANCE PROCEDURES
SHELTER ASSEMBLY
THIS SECTION COVERS:
Inspect, Test, Replace, Repair
INITIAL SETUP:
CK set up for operation
Maintenance Level
Unit
Tools and Special Tools
Tool Kit, General Mechanic's (WP 0052 00, Table 1, Item 1)
GENERAL
This procedure contains information and instructions for inspecting and making repairs to the
Shelter Assembly. Refer to WP 0034 00 for repair parts information.
INSPECT
Inspect the orange safety straps for cuts and signs of deterioration.
Inspect the winch cables for frayed wires or flat spots.
Inspect the tent and awning fabric for cuts or tears.
Inspect the exterior drain hose for cracks, cuts, and missing or damaged gaskets.
TEST
Safety Strap: Follow the Shelter Expansion procedure in WP 0006 00 to lower the applicable
wing until the orange safety strap is almost tight. The orange safety strap is to be replaced if it
is broken, frayed at the edges or it is evident that the strap will not support the weight of the
shelter floor as it is being lowered. There is no repair for the safety strap. It must be replaced.
Refer to the following section for the repair procedure.
Winch Assembly: Follow the Shelter Expansion or Wing Closure procedure as applicable to
lower or raise the applicable wing. The winch should provide a smooth and even cranking
operation. A clicking sound should be heard when the handle is rotated clockwise. There
should not be a clicking sound when the crank is rotated counterclockwise. If a rough,
intermittent, erratic or binding operation occurs, open the winch assembly access panel in the
kitchen area and check that the winch cable is being properly wound on the winch cable reel
assembly. Check the winch cable at each visible area at the container ends and along the wing.
Continue the cranking operation if possible to check the cable along the entire length. The
winch cable is to be replaced if any of the individual cable wires are broken, the cable is kinked
or if there is more than one flat spot anywhere along the cable. Refer to the following section for
the replacement procedure.
0017 00-1