Troubleshooting Procedures - Hand Sink Assembly - Icom IC-M71 Instruction Manual

CONTAINERIZED KITCHEN (CK)
TROUBLESHOOTING PROCEDURES (HAND SINK ASSEMBLY)
THIS WORK PACKAGE COVERS:
Hand Sink Assembly
INITIAL SETUP:
CK set up
Maintenance Level
Operator/Crew
HAND SINK ASSEMBLY MALFUNCTIONS
Table 1. Troubleshooting Procedures (Hand Sink Assembly)
Malfunction
No hot or cold water
Low water pressure
TM 10-7360-226-13&P
Test or Inspection
Water pump running
Check hoses for kinks,
obstructions, leaks, missing
washers
Supply valve from tank trailer open
Pump will not run
Check hoses for kinks,
obstructions, leaks, missing
washers
Supply valve from tank trailer open
0013 00-1
Corrective Action
Immediately turn water heater
OFF (appliance control box)
Remove kinks, tighten loose or
leaking fittings, repair/replace
damaged hose
Check/open valve
Notify unit maintenance
Immediately turn water heater
OFF (appliance control box)
Check/plug in pump power cord
Verify pump switch is ON
(appliance control box)
Verify appliance control box is
plugged in
Check/reset pump circuit
breaker (appliance control box)
Check/reset appliance control
box circuit breaker (#24 on
Power Distribution Panel)
Notify unit maintenance
Remove kinks, tighten loose or
leaking fittings, replace
damaged hose
Check/open valve
0013 00