Icom IC-M71 Instruction Manual page 79

CONTAINERIZED KITCHEN (CK)
OPERATION UNDER USUAL CONDITIONS
Preparation for Packout
Before beginning packout, prepare the CK as follows. Except as noted, these steps may be
performed simultaneously or in any convenient order.
Ensure that all CK components have completely cooled
before initiating packout, or personal injury may result.
1. Turn off all MBUs and the water heater and allow the equipment to cool. If they were
recently used, the steam table, tray pack heater and water heater will contain hot water that
will take an hour or more to cool.
2. Remove all food and trash from the kitchen and clean the utensils, pots, pans, griddle,
grease filters, grease cup, grease trap, table tops, etc. as necessary.
3. Turn off the refrigerators and mobile warming cabinet and clean them.
4. Turn off the cook center ventilation. The generator, lights and ECU may be left on if desired.
5. Disconnect both ends of the water supply hose and internal drain hose. Drain the supply
hose, coil it tightly, and connect its two ends together to minimize the possibility of
contamination. Pack the supply hose on the lower shelf of the sink assembly. If it is not
needed to drain the steam table, coil the internal drain hose and pack it in the back of the
sink assembly.
6. If necessary, drain the steam table after it has cooled. Connect the internal drain hose to
the steam table drain connection and the floor drain connection. Remove the stopper and
allow the table to drain. Replace the stopper when draining is complete. Disconnect the
drain hose, coil it, and pack it in the back of the sink assembly. If necessary, remove the
floor drain cover and clean the drain.
7. After it has cooled, drain the water heater. Open both faucet valves, both drain valves
(located under the water heater) and collect the water in a suitable container. Close all of
the valves when draining is complete. The collected water can be poured into the floor
drain.
8. If the tray pack heater must be drained, leave the external drain hose in place – it will be
removed later. If not, disconnect the hose and drain it. Coil it tightly, and pack it on the
lower shelf of the sink assembly. Install the cap on the external drain connection.
TM 10-7360-226-13&P
WARNING
0006 00-26
0006 00