Installing The Intel Rmm And Intel Rmm Nic - Intel SERVER SYSTEM SR2500AL User Manual

Installing and Removing the Intel
Management Module and the Intel
Installing the Intel
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the PCI riser assembly. For instructions, see
Assembly".
5. Squeeze the sides of the Intel
server system back panel and remove it. See letter "A" in the following figure.
6. A self-adhesive foam gasket is required to protect the underside of the NIC module.
Remove the backing paper from the spacer and install as illustrated (see letter "B"
in the following figure).
7. Attach the standoffs to the server board (see letter "C" in the following figure) and
attach the Intel
following figure).
8. Insert the standoff into the hole labeled TH4 on the Intel
"E" in the following figure). The standoff installs on the bottom side of the Intel
RMM board.
68
®
RMM and Intel
®
RMM NIC module cover to disengage it from the
®
RMM NIC module to the server board (see letter "D" in the
®
Remote
®
RMM NIC
®
RMM NIC
"Removing the System
"Removing the PCI Riser
®
RMM board (see letter
Intel® Server System SR2500AL User's Guide
"Safety
®