Replacing the Power Distribution Module
To replace the power distribution module, use the following instructions.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the large air baffle. For instructions, see
5. Remove the fan module assembly. For instructions, see
6. Disconnect all power cables from the server board, backplane, and mid-plane.
7. Remove the hot-swap power supply/supplies. For instructions, see
Power
8. Remove the two screws to release the module (see letter "A").
9. Lift the module from the server system (see letter "B").
10. Set the replacement power supply distribution module into the server system and
screw the module into place.
11. Install the hot-swap power supply/supplies. For instructions, see
Power
88
Supply".
A
B
A
Figure 78. Removing the Power Distribution Module
Supply".
"Removing the System
"Removing the Large Air
"Replacing a Fan
Intel® Server System SR2500AL User's Guide
"Safety
Baffle".
Module".
"Replacing the
AF000146
"Replacing the