Installing and Removing the Server Board
Installing the Server Board
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the processor air duct. For instructions, see
Duct".
5. Remove the PCI riser assembly. For instructions, see
Assembly".
6. Remove the optical drive cable if installed.
7. Remove the bridge board. For instructions, see
Board from the Server System" on page
8. Remove the large air baffle. For instructions, see
9. Remove the fan module assembly. For instructions, see
10. Place the server board into the server system as shown in the figure below (see
letter "A"), and attach the server board with six screws (see letter "B").
Intel® Server System SR2500AL User's Guide
B
Figure 71. Installing the Server Board
"Removing the System
"Removing the Processor Air
"Removing the PCI Riser
Figure 61 "Removing the Bridge
-71.
"Removing the Large Air
"Replacing a Fan
A
AF000025
"Safety
Baffle".
Module".
81