Replacing A Fixed Fan Module - Intel SERVER SYSTEM SR2500AL User Manual

14. Install the bridge board. For instructions, see
Board into the Server System" on page
15. Install the optical drive cable (optional).
16. Install the PCI riser assembly. For instructions, see
Assembly".
17. Install the processor air duct. For instructions, see
Duct".
18. Install the server system cover. For instructions, see
Cover".
19. Plug all peripheral devices and the AC power cable(s) into the server.

Replacing a Fixed Fan Module

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the processor air duct. For instructions, see
Duct".
5. Remove the PCI riser assembly. For instructions, see
Assembly".
6. Remove the optical drive cable if installed.
7. Remove the bridge board. For instructions, see
Board from the Server System" on page
8. Remove the large air baffle. For instructions, see
9. Disconnect the fan cables from the mid-plane.
Intel® Server System SR2500AL User's Guide
Figure 64 "Installing the Bridge
-73.
"Installing the PCI Riser
"Installing the Processor Air
"Installing the Server System
"Removing the System
"Removing the Processor Air
"Removing the PCI Riser
Figure 61 "Removing the Bridge
-71.
"Removing the Large Air
"Safety
Baffle".
93