Replacing A Redundant System Fan - Intel SERVER SYSTEM SR2500AL User Manual

12. Connect the fan cables to the mid-plane.
13. Install the large air baffle. For instructions, see
14. Install the bridge board. For instructions, see
Board into the Server System" on page
15. Install the optical drive cable (optional).
16. Install the PCI riser assembly. For instructions, see
Assembly".
17. Install the processor air duct. For instructions, see
Duct".
18. Install the server system cover. For instructions, see
Cover".
19. Plug all peripheral devices and the AC power cable(s) into the server.

Replacing a Redundant System Fan

Note: The fans that are integrated into the power supply cannot be replaced separately. If one of
the fans in the power supply fails, the power supply must be replaced.
The system fans at the front of the server system can be individually replaced if one of
them fails. Use the steps below to replace a system fan.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Remove the server system cover. For instructions, see
Cover".
3. There are no screws to loosen. Lift the failed fan from the module.
Intel® Server System SR2500AL User's Guide
"Installing the Large Air
Figure 64 "Installing the Bridge
-73.
"Installing the PCI Riser
"Installing the Processor Air
"Installing the Server System
"Removing the System
Baffle".
"Safety
95