Removing The Server Board - Intel SERVER SYSTEM SR2500AL User Manual

11. Connect all power cables to the server board.
12. Install memory. For instructions, see
13. Install processor(s). For instructions, see
14. Install the fan module assembly. For instructions, see
15. Install the large air baffle. For instructions, see
16. Install the bridge board. For instructions, see
Board into the Server System" on page
17. Install the optical drive cable (optional).
18. Install the PCI riser assembly. For instructions, see
Assembly".
19. Install the processor air duct. For instructions, see
Duct".
20. Install the server system cover. For instructions, see
Cover".
21. Plug all peripheral devices and the AC power cable(s) into the server.

Removing the Server Board

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the processor air duct. For instructions, see
Duct".
5. Remove the PCI riser assembly. For instructions, see
Assembly".
6. Remove the optical drive cable if installed.
7. Remove the bridge board. For instructions, see
Board from the Server System" on page
8. Remove the large air baffle. For instructions, see
9. Remove the fan module assembly. For instructions, see
10. Disconnect all cables from the server board.
11. Remove memory. For instructions, see
12. Remove the processor(s). For instructions, see
82
"Installing DIMMs".
"Installing the Processor".
"Replacing a Fan
"Installing the Large Air
Figure 64 "Installing the Bridge
-73.
"Installing the PCI Riser
"Installing the Processor Air
"Installing the Server System
"Removing the System
"Removing the Processor Air
"Removing the PCI Riser
Figure 61 "Removing the Bridge
-71.
"Removing the Large Air
"Replacing a Fan
"Removing DIMMs".
"Removing a
Intel® Server System SR2500AL User's Guide
Module".
Baffle".
"Safety
Baffle".
Module".
Processor".