Replacing The Control Panel - Intel SERVER SYSTEM SR2500AL User Manual

12. Connect all power cables to the server board.
13. Install the fan module assembly. For instructions, see
14. Install the large air baffle. For instructions, see
15. Install the server system cover. For instructions, see
Cover".
16. Plug all peripheral devices and the AC power cable(s) into the server.

Replacing the Control Panel

The steps for replacing the standard control panel and the Intel
nearly identical. Use the steps below for both varieties of the control panel. Where
necessary, differences between the two control panels are noted.
Your server must be operated with a control panel installed.
Caution: The control panel is NOT hot swappable. Before removing or replacing the control panel,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the front bezel if it is installed. For instructions, see
Bezel".
4. Remove the server system cover. For instructions, see
Cover".
Intel® Server System SR2500AL User's Guide
"Replacing a Fan
"Installing the Large Air
"Installing the Server System
®
Local Control Panel are
"Removing the Front
"Removing the System
Module".
Baffle".
"Safety
89