Verifying Proper Operation Of Key System Lights; Confirming Loading Of The Operating System; Specific Problems And Corrective Actions - Intel SERVER SYSTEM SR2500AL User Manual

Caution: Turn off devices before disconnecting cables: Before disconnecting any peripheral cables
from the system, turn off the system and any external peripheral devices. Failure to do so
can cause permanent damage to the system and/or the peripheral devices.
1. Turn off the system and all external peripheral devices. Disconnect each device
from the system, except for the keyboard and the video monitor.
2. Make sure the system power cord is plugged into a properly grounded AC outlet.
3. Make sure your video display monitor and keyboard are correctly connected to the
system. Turn on the video monitor. Set its brightness and contrast controls to at
least two thirds of their maximum ranges (see the documentation supplied with
your video display monitor).
4. If the operating system normally loads from the hard disk drive, make sure there is
no CD-ROM / DVD disk in the optical drive.
5. If the power LED does light, attempt to boot from a USB floppy or from a CD-
ROM disk.
6. Turn on the system. If the power LED does not light, see
Light".

Verifying Proper Operation of Key System Lights

As POST determines the system configuration, it tests for the presence of each mass
storage device installed in the system. As each device is checked, its activity light should
turn on briefly. Check for the following:
•
Does the drive activity light turn on briefly? If not, see
Not
• If system LEDs are illuminated, see
CD-ROM to be the first bootable device."
take to correct the problem.

Confirming Loading of the Operating System

Once the system boots up, the operating system prompt appears on the screen. The prompt
varies according to the operating system. If the operating system prompt does not appear,
see "No Characters Appear on

Specific Problems and Corrective Actions

This section provides possible solutions for these specific problems:
•
Power light does not light.
•
No characters appear on screen.
•
Characters on the screen appear distorted or incorrect.
Intel® Server System SR2500AL User's Guide
Light".
Screen".
"Power Light Does Not
"Drive Activity Light Does
"Make sure the BIOS is configured to allow the
for a description of the light and steps to
113