Rmm2 Nic; Installing The Intel ® Rmm2 And Intel ® Rmm2 Nic - Intel SR1560SF - Server System - 0 MB RAM Service Manual

Installing and Removing the Intel
Management Module 2 and the Intel
Installing the Intel
1. Squeeze the sides of the Intel
server system back panel and remove it.
2. Attach the foam gasket to the bottom of the Intel
"A").
Note: The Intel
order to provide better detail on installing the foam gasket.
3. Attach the standoffs to the server board (see letter "B" in the figure below) and
attach the Intel
4. Insert the standoff into the hole labeled TH4 on the Intel
"D" in the figure below). The standoff installs on the bottom side of the Intel
RMM2 board.
5. Attach the Intel
into the matching hole on the server board (see letter "E" in the figure below).
Figure 46. Installing the Intel
42
®
RMM2 and Intel
®
RMM2 NIC module is shown upside down in the first illustration below in
®
RMM2 NIC module to the server board (see letter "C").
®
RMM2 board to the server board connector and snap the standoff
A
®

RMM2 NIC

®
RMM2 NIC module cover to disengage it from the
®
C
B
®
RMM2 and the Intel
Server System
®
Intel Server System SR1560SF Service Guide
®
Remote
®
RMM 2 NIC
RMM2 NIC module (see letter
®
RMM2 board (see letter
E
D
AF002378
®
RMM2 NIC Module to the
®