Installing A Slimline Optical Drive Or Internal Usb Floppy; Figure 38. Installing An Optical Drive Into The Drive Tray - Intel SERVER SYSTEM SR2500AL User Manual

Installing a Slimline Optical Drive or Internal USB Floppy

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the front bezel if it is installed. For instructions, see
Bezel".
4. Remove the server system cover. For instructions, see
Cover".
5. Insert the interposer board into the optical drive.
6. Obtain the optical drive and the drive tray.
7. Align the two holes on the left edge of the optical drive and interposer board with
the two metal tabs in the tray as shown in
8. Lower the opposite side of the optical drive into the tray until it clicks into place
(see letter "B").
9. Screw the interposer board into the carrier.
10. Insert the optical drive tray assembly into the server system as shown in
(see letter "A").
11. Make sure that the back end of the interposer board plugs into the matching socket
on the backplane (see letter "B").
12. Verify that the blue release lever on the tray locks into place.
13. (Optional) For installing the optional USB floppy drive, note the location of the
backplane USB connector in
documentation that came with the device.
48
A

Figure 38. Installing an Optical Drive into the Drive Tray

Figure 38
Figure 39 (see letter "C") and refer to the
Intel® Server System SR2500AL User's Guide
"Removing the Front
"Removing the System
(see letter "A").
B
TP02147
Figure 39
"Safety