B
10. Close both retention clips.
Note: Make sure that all empty add-in card slots have filler panels installed.
11. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser
12. Install the processor air duct. For instructions, see
Duct".
13. Install the server system cover. For instructions, see
Cover".
14. Plug all peripheral devices and the AC power cable(s) into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the processor air duct. For instructions, see
Duct".
5. Remove the PCI riser assembly. For instructions, see
Assembly".
64
Figure 55. Installing a Full Height Add-In Card
Assembly".
A
C
D
"Installing the Processor Air
"Installing the Server System
"Removing the System
"Removing the Processor Air
"Removing the PCI Riser
Intel® Server System SR2500AL User's Guide
AF000148
"Safety