Replacing A Fan Module; Replacing A Redundant Fan Module - Intel SERVER SYSTEM SR2500AL User Manual

8. Install the server system cover. For instructions, see
Cover".
9. (Optional) Install the front bezel. For instructions, see
10. Plug all peripheral devices and the AC power cable(s) into the server.

Replacing a Fan Module

Replacing a Redundant Fan Module

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see
Cover".
4. Remove the processor air duct. For instructions, see
Duct".
5. Remove the PCI riser assembly. For instructions, see
Assembly".
6. Remove the optical drive cable if installed.
7. Remove the bridge board. For instructions, see
Board from the Server System" on page
8. Remove the large air baffle. For instructions, see
9. Disconnect the fan cables from the mid-plane.
Intel® Server System SR2500AL User's Guide
"Installing the Server System
"Installing the Front
"Removing the System
"Removing the Processor Air
"Removing the PCI Riser
Figure 61 "Removing the Bridge
-71.
"Removing the Large Air
Bezel".
"Safety
Baffle".
91