Installing And Removing A Slimline Usb Floppy/Cd-Rom / Dvd-Rom Drive Combo; Installing A Slimline Usb Floppy / Cd-Rom / Dvd-Rom Slimline Kit; Figure 41. Removing Drive Cage From Drive Bay - Intel SC5400RA - Server System - 0 MB RAM User Manual

Installing and Removing a Slimline USB Floppy/
CD-ROM / DVD-ROM Drive Combo
Note: You can install either a slimline CD-ROM drive OR a slimline DVD-ROM drive.You
cannot install both.
Note: For Intel supplied CD-ROM/DVD-ROM drives, the correct setting is "No Jumper".
Note: For non-Intel supplied CD-ROM/DVD-ROM drives, see the documentation that came
with your slimline drive for master/slave jumper settings.
Installing a Slimline USB Floppy / CD-ROM / DVD-ROM
Slimline Kit
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server system and unplug all peripheral devices and the AC power
cable.
3. Remove the chassis cover. For instructions, see
page
4. Remove the front bezel. For instructions, see
(Pedestal Only)" on page
5. Remove the two screws that attach the drive cage to the drive bay. See letter "A" in
the following figure.
6. Tilt the rear of the drive cage up and slide it rearward. See letter "B".
7. Lift the drive cage up and out of the drive bay.
42
iii.
24.
26.

Figure 41. Removing Drive Cage from Drive Bay

"Removing the Chassis Cover" on
"Removing the Bezel Assembly
B
A
AF001522
Intel® Server System SC5400RA User's Guide
"Safety