Configuring Automatic Updates - Motorola RFS Series System Reference Manual

3-38 Motorola RF Switch System Reference

3.6 Configuring Automatic Updates

Use the Automatic Updates
the switch is booted. If updates are found since the last time the switch was booted, the updated version is
uploaded to the switch the next time the switch is booted. Enable this option for either the firmware,
configuration file, or cluster configuration file. Motorola recommends leaving this setting disabled if a review
of a new file is required before it is automatically uploaded by the switch.
To enable and configure the automatic update feature for switch firmware, configuration files, and cluster
configurations:
1. Select Switch
2. Refer to the
configuration file updates. If enabled, the located (updated) configuration file will be used with the
switch the next time the switch boots.
Enable
IP Address
User ID
File Name (With
Path)
screen to enable a facility that will poll a server address (you designate) when
> Automatic Updates
Switch Configuration field to enable and define the configuration for automatic
Select the Enable checkbox to allow an automatic configuration file update when
a newer (updated) file is detected (upon the boot of the switch) at the specified IP
address.
Define the IP address
version is detected when the switch is booted, it is uploaded to the switch and
used upon the next boot of the switch.
Enter the User ID required to access the FTP or TFTP server.
Provide the complete and accurate path to the location of the configuration files
on the server. This path must be accurate to ensure that the most recent file is
retrieved.
from the main menu tree.
of the server where the configuration files reside. If a new