Motorola RFS Series System Reference Manual page 245

3. Refer to the Adopted AP
Switch The Switch
each AP. When clustering is enabled on the switch and Cluster GUI is enabled, the
Switch
configuring enabling Cluster GUI, see
MAC Address Displays the radio's first MAC address when it is adopted by the switch.
Model Displays the model number of the Access Port.
AP Type Displays the Access Port type.
Serial Displays the serial number of the Access Port, and is used for switch management
purposes. It is read-only and cannot be modified.
HW Version Displays the hardware version of the Access Port. This information can be helpful
when troubleshooting problems with the Access Port.
IP Address Displays the IP address of the adopted Access Port.
Bootloader Displays the software version the Access Port boots from. This information can be
helpful when troubleshooting problems.
Protocol Version Displays the version of the interface protocol between the Access Port and the
switch. This information can be helpful when troubleshooting problems with the
Access Port.
Fw Version Displays the Access Port firmware version at run time. Use this information to
assess whether the software requires an upgrade for better compatibility with the
switch.
Radio Indices Displays the indices of the radios belonging to the selected Access Port. These
indices are equivalent to a numerical device recognition identifier (index) for the
radio.
Number of Adopted The Number of Adopted APs is the total number of Access Ports currently adopted
APs by Switch.
4. When using clustering and the Cluster GUI feature is enabled, a pull-down menu will be available to
select which cluster members' APs are displayed. To view APs from all cluster members, select
the pull-down menu. To view APs radios from a specific cluster member, select that member's IP address
from the pull-down menu.
5. Click the Export button to export the contents of the table to a Comma Separated Values file (CSV).
screen for the following information:
field displays the IP address of the cluster member associated with
field will be available on the AP configuration screen. For information on
Managing Clustering Using the Web
4-143
Network Setup
UI.
All from