Motorola RFS Series System Reference Manual page 481

1. Select Management Access
2. Refer to the Management Settings
Secure Management Select this checkbox to allow management VLAN access to switch resources. The
(on Management management VLAN is used to establish an IP connection to the switch from a
VLAN only) workstation connected to a port in the VLAN. By default, the active management
VLAN is VLAN 1, but you can designate any VLAN as the management VLAN. Only
one management VLAN can be active at a time. This option is disabled (not
selected) by default.
Enable Telnet Select this checkbox to allow the switch to use a Telnet session for communicating
over the network. This setting is enabled by default.
Port Define the port number used for the Telnet session with the switch. This field is
enabled as long as the Enable Telnet option remains enabled. The default port is
port 23.
Enable SNMP v2 Select this checkbox to enable SNMPv2 access to the switch over the SNMPv2
interface. This setting is enabled by default.
Enable SNMP v3 Select this checkbox to enable SNMPv3 access to the switch over the SNMPv3
interface. This setting is enabled by default.
Retries
Define the number of retries the switch uses to connect to the SNMP interface if
the first attempt fails. The default value is 3 retry attempts.
Timeout
When the provided interval is exceeded, the user is logged out of the SNMP
session and forced re-initiate their connection. The default value is 10 minutes.
Enable HTTP
Select this checkbox to enable HTTP access to the switch. The Hypertext Transfer
Protocol (HTTP) is an application-level protocol for distributed, collaborative,
hypermedia information systems. This setting is enabled by default.
Enable HTTPS
Select this checkbox to enable HTTPS access to the switch. This setting is enabled
by default.
> Access Control from the main menu tree.
field to enable or disable the following switch interfaces:
7-3
Switch Management