Viewing Sensor Information - Motorola RFS Series System Reference Manual

2. Click the Configuration
3. Click the Syslog Config
4. Check the Enable Logging to Syslog Server
Select the logging level from the drop-down menu.
5. Enter the IP address of the external Syslog server in the
6. Click the OK button.
4.9.3.3 Configuring LLDP Settings for Access Port
Link Layer Discovery Protocol (LLDP) is a protocol that enables devices to advertise their capabilities and
media-specific configuration. LLDP provides a standard method of discovering and representing the physical
network connections of a given network management domain.
1. Check the Enable LLDP
2. Enter the refresh interval value in the
which LLDP frames are transmitted on behalf of this LLDP agent.
3. Enter the holdtime multiplier value in the
the 'Refresh Interval' that determines the actual TTL value used in an LLDPDU.
NOTE: As of now, these settings apply only to AP650.

4.9.4 Viewing Sensor Information

Use the Sensor tab to view information on AP300s configured as sensors and if needed revert them to
Access Ports.
To view existing Sensor information:
1. Select Network
tab.
button.
checkbox to enable or disable the transmission of LLDP advertisements.
Refresh Interval
Holdtime Multiplier
> Access Port from the main menu tree.
option to enable logging to an external Syslog server.
Syslog Server IP Addr
field. This parameter indicates the interval at
field. This parameter is a multiplier on
4-149
Network Setup
field.